LTC Timecode Setup
Linear Timecode (LTC) allows you to trigger video and lighting clips using an LTC (SMPTE) audio source.
The MVP listens for the audio signal via its rear input port and fires specific clips when the incoming timecode matches your Timecode Trigger.
1. Hardware Connection
Source: Connect your timecode source into the Pink 1/8" (3.5mm) IN port on the rear of the MVP.
2. Signal Verification (The Input Monitor)
Before programming triggers, you must ensure the MVP is receiving a clear signal.
Navigate to the MVP's Dashboard page.
Start playback on your LTC source.
Check the LTC Counter: You should see the numbers running rapidly (HH:MM:SS:FF).
Troubleshooting Signal Levels:
If the counter is frozen or erratic: The audio volume is likely too low or too loud (clipping).
Fix: Adjust the output volume on your source device up or down until the MVP's LTC Counter runs smoothly and consistently.
3. Creating Triggers
Once your signal is verified, go to the LTC tab in the left sidebar.
Add New Timecode Trigger
Click the toggle switch to enable EDIT MODE on the top right.
Click the blue ADD NEW TIMECODE TRIGGER button.
Select Type: Choose between VIDEO TRIGGER or LIGHTING TRIGGER.
Set the Time: Enter the exact HH (Hours), MM (Minutes), SS (Seconds), and FF (Frames) for the trigger.
Select your Media: Choose the specific video file or lighting clip from the dropdown menu.
Save: Click the SAVE button.
Repeat this process to add all of your LTC triggers.
Managing Triggers
Edit: Click the Pencil Icon next to any trigger to change its settings.
Delete: Click the Trash Can icon to remove a trigger.
Sort: Triggers are automatically sorted chronologically.
Note that the MVP uses LTC as a Start Trigger, not for continuous synchronization.
Behavior: When the incoming timecode matches the Timecode Trigger values (e.g.,
00:01:30:00), the MVP simply presses "Play" on the assigned clip.No Scrubbing: The clip plays at its normal speed. It does not slow down, speed up, or scrub backward if the external timecode changes speed. It purely listens for the specific "Go" frame.
Last updated